FAQ

Does a DENSO Robot come completely ready to use out of the box?
Response There is some preparation required in order to use your DENSO robot and controller. Here is some information that you should know before setup....
Tue, 27 Apr, 2021 at 7:39 PM
Where can I find part's list information?
Go to the Denso Wave home website at    https://www.denso-wave.com/en/  Select “Part List” under the Robotics section&n...
Wed, 21 Jul, 2021 at 1:43 PM
How do I get access to online user manuals?
Response  Included with every shipped robot are two CDs, one with a version of WinCAPS III and one with the owner’s manual set. Also, available on our ...
Tue, 31 Aug, 2021 at 1:39 PM
Where can I find Manuals for the robot?
Response Our product manuals can be viewed either online or offline, depending on preference. They are very comprehensive and cover a wide range of topi...
Tue, 31 Aug, 2021 at 1:38 PM
What are the IP ratings for DENSO robots?
Response IP stands for ingress protection ratings, and DENSO robotics equipment each has IP ratings.  Available ratings can be found in our manuals and ...
Tue, 26 Oct, 2021 at 2:49 PM
Is Food Grade grease available on DENSO robots?
Response DENSO currently offers food-grade H1 type grease on our HSR series robots only.   DENSO also offers Robot Protective Jacket for Food Proces...
Tue, 26 Oct, 2021 at 4:29 PM
How do I get a Declaration of Incorporation or RoHS Certificate of Compliance?
Response DENSO can provide customers with Declarations of Incorporation or RoHS Certificates of Compliance as requested. For a generic form Certific...
Wed, 27 Oct, 2021 at 8:55 AM
How to offset the angle from flange to end of tooling
The angles for your end of arm tooling, Rx, Ry, and Rz, are all set manually as the easy edit option cannot determine how this angle will be based on the...
Wed, 2 Mar, 2022 at 12:25 PM
Environmental, Safety and Hazard Certifications
DENSO robots comply to several conformity standards. These conformities are available in the owner’s manual set from the link below. https://www.fa-manuals...
Wed, 2 Mar, 2022 at 12:30 PM
How to offset the angle from flange to end of tooling
 The angles for your end of arm tooling, Rx, Ry, and Rz, are all set manually as the easy edit option cannot determine how this angle will be based on th...
Wed, 2 Mar, 2022 at 12:46 PM